Here is the scenario: using a spectrum analyzer, I have input values and output values. the number of samples 32000, and the sampling frequency is 2000sample / s, and the input is a sine wave 50 hz, the input current signal, and the output is in psi.
How to calculate the frequency response of this data using MATLAB using the FFT function in MATLAB.
i managed to generate a sine wave that gives magnitude and phase angles, here is the code I used:
%FFT Analysis to calculate the frequency response for the raw data
%The FFT allows you to efficiently estimate component frequencies in data from a discrete set of values sampled at a fixed rate
% Sampling frequency(Hz)
Fs = 2000;
% Time vector of 16 second
t = 0:1/Fs:16-1;
% Create a sine wave of 50 Hz.
x = sin(2*pi*t*50);
% Use next highest power of 2 greater than or equal to length(x) to calculate FFT.
nfft = pow2(nextpow2(length(x)))
% Take fft, padding with zeros so that length(fftx) is equal to nfft
fftx = fft(x,nfft);
% Calculate the number of unique points
NumUniquePts = ceil((nfft+1)/2);
% FFT is symmetric, throw away second half
fftx = fftx(1:NumUniquePts);
% Take the magnitude of fft of x and scale the fft so that it is not a function of the length of x
mx = abs(fftx)/length(x);
% Take the square of the magnitude of fft of x.
mx = mx.^2;
% Since we dropped half the FFT, we multiply mx by 2 to keep the same energy.
% The DC component and Nyquist component, if it exists, are unique and should not be multiplied by 2.
if rem(nfft, 2) % odd nfft excludes Nyquist point
mx(2:end) = mx(2:end)*2;
else
mx(2:end -1) = mx(2:end -1)*2;
end
% This is an evenly spaced frequency vector with NumUniquePts points.
f = (0:NumUniquePts-1)*Fs/nfft;
% Generate the plot, title and labels.
subplot(211),plot(f,mx);
title('Power Spectrum of a 50Hz Sine Wave');
xlabel('Frequency (Hz)');
ylabel('Power');
% returns the phase angles, in radians, for each element of complex array fftx
phase = unwrap(angle(fftx));
PHA = phase*180/pi;
subplot(212),plot(f,PHA),title('frequency response');
xlabel('Frequency (Hz)')
ylabel('Phase (Degrees)')
grid on
i took the frequency response to the phase plot at a phase angle of degree 90, is this the correct way to calculate the frequency response?
, ? , , .