All geek questions in one place

Jmeter Execution Requests

I recently started using Jmeter and ran into some problems. I originally used VSTS.

I have JMX where I recorded and set up a usage example that has 5 steps. Logically, all steps (controllers) must be performed sequentially. I also use two slaves.

  • When I run a 100 Thread test using 2 slave controllers, the controllers are not executed sequentially. Step 1 will first execute 200 times, and then step 2 and so on. How to configure Jmeter for sequential execution of controllers?

  • When I run the test, the response time is long, but Perfmon does not show processor growth, which is rather inconsistent. I performed the same test with VSTS and I got a processor graph. Am I missing any configuration in Jmeter?

  • I performed a load test in Jmeter and VSTS. Use cases and test model were the same in both tools. The results were compared, and there is a big difference between the readings between them. For example: Hits are higher in Jmeter than in VSTS, the average response time is much less in Jmeter compared to VSTS. I could not get the behavior.

  • What is the role of followers in Jmeter?

+4
source share
2 answers

To switch between parallel / sequential modes of "Executing thread groups", you can select the "Run thread groups in sequence" checkbox in the "Test plan" .

, Visual Studio JMeter. , JMeter , , css, ..

HTTP Request Defaults Config Element :

  • . 3-5 .

, , :

JMeter, , JMeter - // / . , JMeter , .

0

, :

I have recently started using Jmeter and facing some issues. Initially I was using VSTS.

Jmeter - , , .

I have a JMX where I have recorded and configured a Use case which has 5 steps. Logically all the steps(controllers) should execute sequentially. Also I am using two slaves.

. / . 4.2.2 http://jmeter.apache.org/usermanual/test_plan.html

When I execute a 100 Thread test using 2 slaves the controllers don't execute sequentially. Step 1 will first execute 200 times and then step 2 and so on. How can i configure Jmeter to execute the controllers sequentially?

, remai,

When I execute the test the response time is high but the Perfmon shows no rise in CPU which is quite contradictory. I executed the same test with VSTS and i got the CPU graph proper. Am i missing any configuration in Jmeter?

JP @GC jmeter, , , , .

I executed a load test in Jmeter and VSTS . The use cases and test model was same in both the tools. The results were compared and there is lot of difference among the readings between the 2. For example: Hits are high in Jmeter than in VSTS, average response time is much lower in Jmeter when compared to VSTS. I was not able to derive the behaviour. , : Cookie, Cookie Manager ( )

.

, Jmeter , (, 10 , jmeter 10 HTTP- , )

What is the role of slaves in Jmeter? http://jmeter.apache.org/usermanual/remote-test.html

0

Source: https://habr.com/ru/post/1548426/

More articles:


All Articles